if u read my mail u will get the answer! change to an ASIO driver. the one with cubase is ok there is an unofficial one on the net which u can search 4 + easily find which has much lower latency.

: Hello,
I want the note of etude of moshkofski (N0.2)
for piano

please send me this program, or else i'm gona freak out with DEMO version.....

[The body of this post has been lost]

Same deal - I have tried about 5 times this afternoon to open an account and all i get is "invalid password"

: I am having the exact same problem...i am sure its not your computer as i have tried to set up on many different computers...

: I opened one account a few weeks ago and that one works smooth, though recently it has been impossible to join as a new member..please let me know if you hear anything

: Rich

: I am looking for a program that will let me convert CD+G files to MP3+G files. I am wanting to take a few of my karaoke discs and put them on my computer for home use. Thanks, Johno

We have a program that strips the graphics off the wave file and converts it to MP3, then marrys it back to the Graphic file. It is made to use with the Hyundai MP3 Jukebox Karaoke Player with a hard drive that can store up to 16,000 songs within the player. You can see the player on our web site www.u-sing-m.com

You will have to figure out how to play the graphics on your computer.... I don't have that.

Good luck

C.C. Grider

yo estoy muy interesado en Mixman Studio, pero no me lo pueden enviar a mi pais, por favor ponte en contacto conmigo.

I am very interested with Mixman Studio but they cannot send to me to my country, please write me

: To write/burn CD+G discs, you must have one of the following recorders:

: Hewlett Packard 7500 / 8100 / 8200 / 9100 / 9200
: Panasonic CW-7501
: Plasmon CDR4240
: Plextor PX-R412C (must have firmware version 1.07)
: Plextor PX-R820T / PX-W4220T / PX-W8220T)
: Sony CRX100E / CRX110E / CRX120E / CRX140E / CRX140S
: Yamaha All Models

:
: : can someone please tell me if there is a free software to copy cd+g. i have a cd burner by yamaha. new at this, sorry.

:
: does anyone a serial for cakewalk 9

:
: does anyone a serial for cakewalk 9

: To write/burn CD+G discs, you must have one of the following recorders:

: Hewlett Packard 7500 / 8100 / 8200 / 9100 / 9200
: Panasonic CW-7501
: Plasmon CDR4240
: Plextor PX-R412C (must have firmware version 1.07)
: Plextor PX-R820T / PX-W4220T / PX-W8220T)
: Sony CRX100E / CRX110E / CRX120E / CRX140E / CRX140S
: Yamaha All Models

:
: : I have some CD+G's(Karaoke Discs) that have become scratched and I would like to make a copy of them before they finally wear out. What kind of CD Burner do I need. I downloaded software for that purpose but it said my CD Burner could not read those types of CD's. I know they have subcodes. Can anyone tell me if there is any hardware available for duplicating my old CD+G's. Thanks

:
: does anyone a serial for cakewalk 9

Yes, cwpa900000000

What is the cd key!!!!!!!!!!!!

:
: does anyone a serial for cakewalk 9

: : : : I am in need of a wave-to-midi converter. If anyone
: : : : have one, or know an URL where I can find it, I would
: : : : be very happy. Have lots of stuff myself if anyone
: : : : need some.

: : Yep, I heard of only one.
: : The name is WinJammer, but I am not sure where it can be found.
: : Greetz,
: : Syntax.

: : : : I HAVE A KORG T1 WHICH I HAVEN'T USED IN YEARS. I WENT TO USE IT AND WAS UNABLE TO CREATE A PROGRAM. WHAT HAVE I FORGOTTEN, (PROBABLY) AM DOING WTONG OR DON'T KNOW. THANKS, IN ADVANCE, FOR YOUR HELP. Mike

: : : Your internal Battery is dead. I believe it is a CR 2032 cell.

: : :Hi, I just replaced the Korg T1 Battery. It requires some work. Here is direction:

: 1. Remove the rear(back side) metal panel(you may want to leave the 3 hinges screws on).

: 2. Battery is on the second PCB counting from the right and reviewed from the rear.

: 3. Battery is loacated underneath the PCB and is bout 1/3 from the right hand edge.

I'm interested in the results...did it work? I found the Korg Factory load PCM card with all the sounds, settings and such, wish there were a way to save this to disk (it appears you can only save sequence information to it).

Thanks,

/B

: : I need T-RackS registration code. Thanx
: : to send it throug e-mail,

: Yo Mark... check this one buddy!

: JJ

DID you ever find an
authorization code? if you did, could you share it with me?

I Need a Dope Wars 2.0 registration code? Does anyone have one or know of somewhere I can get one? Thanx.

: I need T-RackS registration code. Thanx to send it throug e-mail, I'd really appreciate.

Hello Troy and Raymond. I have recently switched over from Opcodes Studios Vision Pro To Cubase VST. I have found the "Electronic Documentation" that comes with the program to be extremely helpful in my conversion. It is located in the Cubase folder on your hard drive. It is extremely detailed. In it you a find "Getting Started" and also a "Getting into the details" PDF documents. I hope this helps and that I have not offened you with this suggestion.

:
: : : How can I convert mp3s so that I can play them with my
: : : CD-player.Please help me!

: : Okay, if you plan to reply, give an answer not the
: : same question.

: : anyways, to convert mp3 to cda, first you must convert
: : the mp3 to wav and from there you should be able to
: : convert to cda

:
: : : How can I convert mp3s so that I can play them with my
: : : CD-player.Please help me!

: : Okay, if you plan to reply, give an answer not the
: : same question.

: : anyways, to convert mp3 to cda, first you must convert
: : the mp3 to wav and from there you should be able to
: : convert to cda